How to install:
I
VENT OUT™
FOR ROOF
MOUNTING
TO 4” ROUND
DUCTS:
-
Drill or cut a 4’’ round hole or 4” x 4” square hole in the roof sheeting from inside the attic.
-
From inside the structure Insert the shorter end of the VENT OUT™ into the hole and lay flange tight against the plywood.Secure to the plywood with 1/2” or longer size screws through at least four of the six pre-drilled holes.
-
Slip inner duct over the ant-slip ring around the VENT OUT™. Tightly secure inner duct with a zip-tie.
-
Pull the insulation up over the already secured flexible duct and secure it with a zip-tie.
-
Attach the other end of the flexible or metal duct to the ventilation fan or dryer.
-
DURING ROOFING: Roofer at time of installing the roofing will remove the disposable cap of the VENT OUT™ and install a permanent vent cap over the hole.
Note:
Procedure is the same for 6”, 8” or 10” ducts.
Exclusive features:
-
Prevents flexible ducts from getting wet
-
Water tight connection with removable cap
-
One time connection of The VENT OUT to roof
-
Eliminates the need for second visit to replace flexible ducts or attach flex ducts to roof
-
Stop costly replacement of wet flexible ducts
The VENT OUT™ is tested to be watertight.
The VENT OUT™ is made of durable materials to withstand the temperature range in hot and cold climates.